Friday, April 10, 2009

Essentials of Broadband Routers

Broadband router is internet speed computer based device which is mainly used for setting up a network. The network can be either wired or a wireless network. These broadband routers are used to ensure that all the systems in a network can transmit data with each other across the broadband Internet. As the features of broadband devices are similar, you can visit kuala lumpur them for both wired celcom broadband streamyx promotion wireless networks with its support.

The main need for these types of devices is while transmitting data. These devices have the stuff to transmit data between the distinct networks as data packets. Information is mostly transmitted from one system to other as packets of data. The basic requirement of this type of transmission is that two networks are needed to connect a router. fiber internet broadband router has to be used to connect those networks to transmit data between each other. These routers are performed as a gateway for those networks.

After connecting the two networks with each other by using broadband routers, now the computer users can share the Internet access easily. The data will be directed along with the computer on local network through the Internet. Data can be exchanged even to computers which are kept at a distant. The added advantage of these broadband routers is to find out the virus attacks. The presence of a router becomes essential in a network to find out hacking threats and virus attacks. Broadband routers can be used as a filter. Most of the broadband high speed internet phone are not featured with in-built security features. Therefore if you use a network without router, it may welcome on-line hackers. You can get routers with built-in firewall features. It will be useful for you to have a safe and secure wired or wire-free network.

Types of Broadband Routers
Broadband routers can be two types. One is ADSL modem router and the other is a cable routers. ADSL modem routers can only be used for ADSL broadband connections where as cable routers can also be used for cable broadband users. The mode of performance is similar in these two types of routers. The main dissimilarity between these two broadband routers is the mode of connection. ADSL Modem routers can easily be connected just by plug-in to share Internet connection. In malaysia hotels of cable routers, cable sockets and ports have to be used for getting the connection.

Read streamyx bridge about Broadband Modems, Routers in broadbandsuppliers.co.uk and you can read broadband beginners Guide to know the basic of broadband. Experts and other members of UK Broadband Forum will always ready to answer your questions.

Images of the Zune HD have leaked to engadget this afternoon and since then, blogs like Technologizer have pinged their sources deep in Microsoft to learn that it is indeed a genuine shot. These images are promotional materials to be used by Microsoft’s telekom The little story would be that a graphic design company pissed by


3rd Adenhart Crash Victim Identified

Filed under:

The 3rd kuala lumpur flights of the tragic car wreck that killed baseball star Nick Adenhart has been identified as 25-year-old Henry Nigel Pearson. Henry, internet speed test was also wireless isp baseball enthusiast, was friends with the only survivor from the Mitsubishi -- Jon fastest broadband ...

Permalink



When would YOU choose DSL, T1, or DS3 Bandwidth as the network solution broadband speed availability your business .... streamyx jumper why/why not? What are the pros and cons for and against each bandwidth type in a business setting?

In general .....

The answer to these questions is truly related to your application requirements. If you run applications that are latency or Jitter impacted, then DSL may not provide you with the service levels you need.

An additional extension of that would be your requirements for uptime. MTTR (Mean Time to Repair) is typically greatly improved with DS1 and DS3 circuits.

The size of the business is not nearly as important as your application requirements. Many large organizations can survive with DSL or in some cases dial-up, but a small organization that has streaming application traffic, cyberjaya malaysia critical traffic, or small latency or jitter requirements then DS1 or streamyx promo connectivity would be required.

Lastly, though often primarily, cost helps determine your choices.

To be more specific ....

T1s and DS-3s give the same offering except for capacity. T1s give 1.5Mbps upload and download speeds per line. DS3s give 32-45mbps upload and download speeds.

ADSL typically give asymmetric upload and download speeds (ADSL) typically 1.5, 3.0 and 6.0 Mbps download speeds and somewhere between 128 -768Mbps upload speeds.

Symmetrical DSL (SDSL) gives the same upload and download speeds, typically 384, 512 or 786Mbps upload and download.

Cable offerings vary with providers and location. Doing a comparison with cable would be impossible without knowing your provider and streamyx zone locations Not who your provider is and your location .... but knowing how your provider is in that particular market. Ask a local expert for that detail.

T1 and DS3 are very reliable with high MTBF (mean time between failure) and low MTTR (mean time to repair). Cable and DSL kuala lumpur tourist the other side.

T1 and DS3 expensive, Cable and DSL more affordable.

If you do not have a need for high upload speeds, (VPN, VoIP, high Data transfer for backup/co-location, malaysia airlines streaming media or other high bandwidth services hosted in-house, etc) then speed asymmetric connection is not evil. DSL/Cable may be a good choice in that case.

If you need high speed upload then T1/DS3 is needed.

Fro growing needs, T1 or fractional T3 is a good choice. After some point in growth, a dial up internet service T3/DS3 becomes more economical.

For mission critical networks, two providers from two different physical points-of-entry may be necessary depending on the natural disasters you are likely to face.

Case study one: a company had a fractional T3 coming in from the East and another fractional T3 coming in from the West. Flooding and a sinkhole cut one T3. The network slowed down but stayed up.

Case study two: a company in South Florida lost its T1s and failed over to a Satellite link. Certain services were crippled by the latency of the system but their mission-critical applications kept running.

Which brings malaysia airlines kuala lumpur to Satellite: usually asymmetric with extremely fast downloads (depending on service level) but typically slow uploads (but varies depending on service level). Has an intrinsic latency due to the speed of light and the distance of satellites. Advantage: natural disaster resistant, reliable, available everywhere and no last-mile issues.

In short...here's the 3 most important factors to consider.....

1- Link Speed and Committed Rate

T1 or DS3 can be purchased as dedicated point to point bandwidth. You will get the advertised speed guaranteed from point a to point b. KEY POINT if you are purchasing broadband internet companies to the internet and using the Internet to provide connectivity (VPN etc) then you are buying an on-ramp, the traffic on the "highway" after you get on could slow you down. Just because you bought a DS3 to the Internet doesn't mean that you will have DS3 access to everything onthe Internet.

2- Link Symmetry

T1 and DS3 give the same bandwidth in both directions when configured as point to point. Different flavors of DSL provide different up and downlink speeds.

3- QOS

T1 and DS3 are configurable to support TDM voice (straight out of your PBX). They can also support VoIP. If you are doing everything with VoIP it may not matter. If you are keeping some TDM voice it matters a lot.

For more help to find EXACTLY the right solution for your business network .... take advantage of the free services provided through DS3-Bandwidth.com. This comes in pretty handy considering how complicated evaluating your options could be. Plus using a free service such as this maximizes your resources .... time, malaysian islands and manpower.

Michael is the owner of FreedomFire Communications....including DS3-Bandwidth.com and Business-VoIP-Solution.com. Michael also authors Broadband Nation where you're always welcome to drop in and catch up on the latest BroadBand news, tips, insights, and install streamyx for the masses.


This page is powered by Blogger. Isn't yours?